Mytek-digital Private-Q DL Cable Assembly Using Canare MR202-16A Instrukcja Użytkownika

DL Cable AssemblyUsing Canare MR202-16AT1. Cut a 4 inch piece of ¾ inch diameter black heatshrink and slip it on to the cable.2. Remove ~3 inches of t

19. Solder the remaining ground and -29V wire. Ground should come in from the right side and wire 16 from the left. This is tricky so be patient and t

21. Check for shorts between the power rows with a meter. Once verified that there are indeed no shorts, hot glue the 3 rows so that they dont move ar

23. Insert 1-5, starting with 5.24. Now push and bend the wires so that they are flat and close to the connector. Slide the 4 inch ¾ diameter heatshri

25. Prepare your DL cover.26. Secure the half of the DL cover that has the cover tab. You'll have to maneuver the large cable through the opening

27. Snap the other half on. It is easiest if you slide the remaining half on upright from the side. You will have to bend the locking tabs on top a li

29. Insert the bottom part in the same fashion. Once in, stick the large screw through both pieces and then secure it with a nut. Try not to let the h

The female connector is similar in construction except that you dont cut wires 6,12,13,14,15, and 16 in half, and it is mirrored to the male DL. IMPOR

ReferenceResistor Color Code Wire # (Solid-Stripe)Black = 0 Black-Brown = 01 Black-Whi

3. Separate wires 6, 12, 13, 14, 15, and 16. Cut them in half. Use the resistor color code to number wires. (Ex. Black-Brown stripe = 01, Black-Red st

5. Cut 12 ½-inch pieces of 3/32 inch diameter black heatshrink and place it on wires 1-12. 6. Strip ~1 inch of the jacket off cables 1-12 and remove t

7. Separate the 3 wires and place clear 1/32 inch diameter clear heatshrink on the bare ground wire. To cut the proper length slide the clear heatshri

9. Strip ~1/8 inch off the end of the other wires.10. Proceed to crimp the pins on to cables 1-12. Be sure to use the smaller gauge crimp.

11. Now prepare the power and ground wires (13,14 = GND, 15 = +29V, 16 = -29V) by stripping off ~1/4 inch and also completely stripping the 3 inner wi

13. Insert them in to row H first. It is VERY IMPORTANT that you look at and take notice of the markings on the connector so that you do not accidenta

15. Do steps 13-14 to rows J and K. Careful not to solder the rows together.16. Place a small piece of black heatshrink on the GND,+, and -. GND will

17. One end of the cable will have the wires arranged so that it will comfortably connect to the connector. The other end will be mirrored. In the cas